kernel.git/include/net/bluetooth/hci.h, branch linux-3.13.y

Bluetooth: Add support for setting DUT mode

2013-10-19T15:56:56Z

The Device Under Test (DUT) mode is useful for doing certification testing and so expose this as debugfs option. This mode is actually special since you can only enter it. Restoring normal operation means that a HCI Reset is required. The current mode value gets tracked as a new device flag and when disabling it, the correct command to reset the controller is sent. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: Add support for setting SSP debug mode

2013-10-19T15:56:52Z

Enabling and disabling SSP debug mode is useful for development. This adds a debugfs entry that allows to configure the SSP debug mode. On purpose this has been implemented as debugfs entry and not a public API since it is really only useful during testing and development. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: Remove enable_hs declaration

2013-10-16T09:28:25Z

This seems to be a left-over. The module parameter enable_hs has been removed, but its extern declaration is still present. It is not needed anymore, so just remove it. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: Remove duplicate definitions for advertising event types

2013-10-16T07:31:48Z

The constants for advertising event types have been defined twice. So remove one copy of it. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: Set the scan response data when needed

2013-10-16T07:31:24Z

On controller power on and when enabling LE functionality, make sure that also the scan response data is correctly set. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: Add HCI command structure for writing current IAC LAP

2013-10-15T15:44:24Z

This patch just adds the HCI command structure for configuring the current IAC LAP setting. The length of the command is variable and supports more than two IAC. However since there is only general discoverable and limited discoverable modes, this can be limited to two possible IACs. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: Introduce flag for limited discoverable mode

2013-10-15T14:20:15Z

Add a new flag that can be set when in limited discoverable mode. This flag will cause the limited discoverable bit in the class of device value to bet set. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: Read current IAC LAP on controller setup

2013-10-14T22:31:18Z

Read the current IAC LAP values when initializing the controller. The values are not used, but it is good to have them in the trace files for debugging purposes. Signed-off-by: Marcel Holtmann Signed-off-by: Gustavo Padovan

Bluetooth: Read number of supported IAC on controller setup

2013-10-14T22:31:12Z

When initializing a controller make sure to read out the number of supported IAC and store its result. This value is needed to determine if limited discoverable for BR/EDR can be configured or not. Signed-off-by: Marcel Holtmann Signed-off-by: Gustavo Padovan

Bluetooth: Read location data on AMP controller init

2013-10-07T14:53:40Z

When initializing an AMP controller, read its current known location data so that it can be analyzed later on. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg