kernel.git/drivers/spi/Makefile, branch linux-2.6.33.y

spi: Add s3c64xx SPI Controller driver

2009-12-17T15:58:17Z

Each SPI controller has exactly one CS line and as such doesn't provide for multi-cs. We implement a workaround to support multi-cs by _not_ configuring the mux'ed CS pin for each SPI controller. The CS mechanism is assumed to be fully machine specific - the driver doesn't even assume some GPIO pin is used to control the CS. The driver selects between DMA and POLLING mode depending upon the xfer size - DMA mode for xfers bigger than FIFO size, POLLING mode otherwise. The driver has been designed to be capable of running SoCs since s3c64xx and till date, for that reason some of the register fields have been passed via, SoC specific, platform data. Signed-off-by: Jassi Brar Signed-off-by: Grant Likely

spi_s3c24xx: add FIQ pseudo-DMA support

2009-12-17T15:57:01Z

Add pseudo-DMA by FIQ to the S3C24XX SPI driver. This allows the driver to get DMA-like performance where there are either no free DMA channels or when doing transfers that required both TX and RX data paths. Since this patch requires the addition of an assembly file to hold the FIQ code, we rename the module (instead of adding a rename of the .c file to this patch). We expect most users are loading this via udev and thus there should be no change to the userland configuration. Signed-off-by: Ben Dooks Signed-off-by: Simtec Linux Team Cc: David Brownell Signed-off-by: Andrew Morton Signed-off-by: Grant Likely

spi: controller driver for Designware SPI core

2009-12-17T15:39:13Z

Driver for the Designware SPI core, it supports multipul interfaces like PCI/APB etc. User can use "dw_apb_ssi_db.pdf" from Synopsys as HW datasheet. [randy.dunlap@oracle.com: fix build] [akpm@linux-foundation.org: build fix] Signed-off-by: Feng Tang Cc: David Brownell Signed-off-by: Randy Dunlap Signed-off-by: Andrew Morton Signed-off-by: Grant Likely

Add OMAP spi100k driver

2009-12-13T08:02:11Z

This change adds the OMAP SPI 100k driver created by Fabrice Crohas . This SPI bus is found on OMAP7xx-series smartphones, and for many, the touchscreen is attached to this bus. The lion's share of the work was done by Fabrice on this driver -- I am merely porting it from the Linwizard project on his behalf. Signed-off-by: Cory Maccarrone Signed-off-by: Grant Likely

ARM: NUC900: Add spi driver support for nuc900

2009-12-13T07:58:00Z

Signed-off-by: Wan ZongShun Signed-off-by: Grant Likely

spi: SuperH MSIOF SPI Master driver V2

2009-12-13T07:48:27Z

This patch is V2 of SPI Master support for the SuperH MSIOF. Full duplex, spi mode 0-3, active high cs, 3-wire and lsb first should all be supported, but the driver has so far only been tested with "mmc_spi". The MSIOF hardware comes with 32-bit FIFOs for receive and transmit, and this driver simply breaks the SPI messages into FIFO-sized chunks. The MSIOF hardware manages the pins for clock, receive and transmit (sck/miso/mosi), but the chip select pin is managed by software and must be configured as a regular GPIO pin by the board code. Performance wise there is still room for improvement, but on a Ecovec board with the built-in sh7724 MSIOF0 this driver gets Mini-sd read speeds of about half a megabyte per second. Future work include better clock setup and merging of 8-bit transfers into 32-bit words to reduce interrupt load and improve throughput. Signed-off-by: Magnus Damm Signed-off-by: Grant Likely

xilinx_spi: add a platform driver using the xilinx_spi common module.

2009-12-09T01:48:14Z

This patch adds in a platform device driver using the xilinx_spi common module. Tested-by: John Linn Signed-off-by: Richard Röjfors Signed-off-by: Grant Likely

xilinx_spi: Split into of driver and generic part.

2009-12-09T01:48:14Z

This patch splits the xilinx_spi driver into a generic part and a OF driver part. The reason for this is to later add in a platform driver as well. Tested-by: John Linn Signed-off-by: Richard Röjfors Signed-off-by: Grant Likely

powerpc/5200: Add mpc5200-spi (non-PSC) device driver

2009-11-04T22:34:18Z

Adds support for the dedicated SPI device on the Freescale MPC5200(b) SoC. Signed-off-by: Grant Likely

spi-imx: rename source file to spi_imx.c

2009-10-01T23:11:16Z

This makes the filename match the Kconfig symbol and the driver name. Signed-off-by: Uwe Kleine-König Cc: Sascha Hauer Cc: David Brownell Cc: Guennadi Liakhovetski Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds