kernel.git/drivers/serial/Makefile, branch linux-2.6.21.y

[PATCH] PNX8550 UART driver

2007-02-14T16:09:52Z

Add UART support for PNX8330/8550/8950 Philips MIPS-based SoCs. Signed-off-by: Vitaly Wool Cc: Russell King Cc: Alan Cox Cc: Ralf Baechle Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

[POWERPC] Open Firmware serial port driver

2007-02-14T00:50:04Z

This can be used for serial ports that are connected to an OF platform bus but are not autodetected by the lecacy serial support. It will automatically take over devices that come from the legacy serial detection, which usually is only one device. In some cases, rtas may be set up to use the serial port in the firmware, which allows easier debugging before probing the serial ports. In this case, the "used-by-rtas" property must be set by the firmware. This patch also adds code to the legacy serial driver to check for this. Signed-off-by: Arnd Bergmann Signed-off-by: Paul Mackerras

[PATCH] Exar quad port serial

2006-12-07T16:39:35Z

This is on our "Envoy" boxes which we have, according to the documentation, an "Exar ST16C554/554D Quad UART with 16-byte Fifo's". The box also has two other "on-board" serial ports and a modem chip. The two on-board serial UARTs were being detected along with the first two Exar UARTs. The last two Exar UARTs were not showing up and neither was the modem. This patch was the only way I could the kernel to see beyond the standard four serial ports and get all four of the Exar UARTs to show up. [akpm@osdl.org: build fix] Signed-off-by: Paul B Schroeder Cc: Lennart Sorensen Acked-by: Alan Cox Cc: Russell King Cc: Greg KH Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

[PATCH] serial uartlite driver

2006-12-07T16:39:30Z

Add a driver for the Xilinx uartlite serial controller used in boards with the PPC405 core in the Xilinx V2P/V4 fpgas. The hardware is very simple (baudrate/start/stopbits fixed and no break support). See the datasheet for details: http://www.xilinx.com/bvdocs/ipcenter/data_sheet/opb_uartlite.pdf See http://thread.gmane.org/gmane.linux.serial/1237/ for the email thread. Signed-off-by: Peter Korsgaard Acked-by: Olof Johansson Cc: Russell King Cc: Alan Cox Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

[PATCH] at91_serial -> atmel_serial: Kconfig symbols

2006-10-04T17:25:05Z

Rename the following Kconfig symbols: * CONFIG_SERIAL_AT91 -> CONFIG_SERIAL_ATMEL * CONFIG_SERIAL_AT91_CONSOLE -> CONFIG_SERIAL_ATMEL_CONSOLE * CONFIG_SERIAL_AT91_TTYAT -> CONFIG_SERIAL_ATMEL_TTYAT Signed-off-by: Haavard Skinnemoen Acked-by: Andrew Victor Signed-off-by: Linus Torvalds

[PATCH] at91_serial -> atmel_serial: at91_serial.c

2006-10-04T17:25:05Z

Rename at91_serial.c atmel_serial.c Signed-off-by: Haavard Skinnemoen Acked-by: Andrew Victor Signed-off-by: Linus Torvalds

[ARM] 3571/1: netX: serial driver for Hilscher netX

2006-06-19T12:29:07Z

Patch from Sascha Hauer This patch adds the serial driver for Hilscher's netX network processors. Signed-off-by: Robert Schwebel Signed-off-by: Sascha Hauer Signed-off-by: Russell King

[SERIAL] Allow 8250 PCI, PNP, GSC and HP300 support to be disabled

2006-03-29T21:03:38Z

Allow the 8250 probe modules to be disabled if we're building for with EMBEDDED enabled. This reduces the kernel size by not including unnecessary probe module support. Original idea from Matt Mackall for PCI only, expanded to others by rmk. Signed-off-by: Russell King

[SERIAL] Remove obsoleted au1x00_uart driver

2006-03-26T20:25:57Z

As announced in feature-removal-schedule.txt. Signed-off-by: Ralf Baechle Signed-off-by: Russell King

[SERIAL] remove 8250_acpi (replaced by 8250_pnp and PNPACPI)

2006-03-25T17:49:47Z

With the combination of PNPACPI and 8250_pnp, we no longer need 8250_acpi. Signed-off-by: Bjorn Helgaas Signed-off-by: Russell King