kernel.git/drivers/regulator/of_regulator.c, branch linux-4.6.y

Merge remote-tracking branches 'regulator/topic/mt6397', 'regulator/topic/of', 'regulator/topic/pv88060', 'regulator/topic/pwm' and 'regulator/topic/s2mps11' into regulator-next

2016-03-13T08:20:00Z

regulator: of: Use of_property_read_u32() for reading min/max

2016-03-12T05:59:33Z

OF interface provides to read the u32 value via standard interface of_property_read_u32(). Use this API to read "regulator-min-microvolts" and "regulator-max-microvolt". This will make consistent with other property value reads. Signed-off-by: Laxman Dewangan Signed-off-by: Mark Brown

regulator: core: Add support for active-discharge configuration

2016-03-02T14:13:05Z

Add support to enable/disable active discharge of regulator via machine constraints. This configuration is done when setting machine constraint during regulator register and if regulator driver implemented the callback ops. Signed-off-by: Laxman Dewangan Signed-off-by: Mark Brown

regulator: Introduce property to flag set-load support

2015-09-17T11:14:12Z

Introduce "regulator-allow-set-load" property to make it possible to flag in the board configuration that a regulator is allowed to have the load requirements changed. Signed-off-by: Bjorn Andersson Signed-off-by: Mark Brown

regulator: Add over current protection (OCP) support

2015-07-24T17:28:46Z

Some regulators can automatically shut down when they detect an over current event. Add an op (set_over_current_protection) and a DT property + constraint to support this capability. Signed-off-by: Stephen Boyd Signed-off-by: Mark Brown

Merge remote-tracking branches 'regulator/topic/of', 'regulator/topic/pwm', 'regulator/topic/qcom' and 'regulator/topic/soft-start' into regulator-next

2015-06-22T10:19:56Z

Merge remote-tracking branches 'regulator/topic/da9063', 'regulator/topic/doc', 'regulator/topic/fan53555', 'regulator/topic/gpio' and 'regulator/topic/ilim' into regulator-next

2015-06-22T10:19:52Z

regulator: Add input current limit support

2015-06-12T12:18:02Z

Some regulators can limit their input current (typically annotated as ilim). Add an op (set_input_current_limit) and a DT property + constraint to support this. Signed-off-by: Stephen Boyd Signed-off-by: Mark Brown

regulator: Add soft start support

2015-06-12T12:16:57Z

Some regulators support a "soft start" feature where the voltage ramps up slowly when the regulator is enabled. Add an op (set_soft_start) and a DT property + constraint to support this. Signed-off-by: Stephen Boyd Signed-off-by: Mark Brown

regulator: Add pull down support

2015-06-12T12:09:43Z

Some regulators need to be configured to pull down a resistor when the regulator is disabled. Add an op (set_pull_down) and a DT property + constraint to support this. Signed-off-by: Stephen Boyd Signed-off-by: Mark Brown