kernel.git/drivers/power/supply/Makefile, branch linux-6.4.y

Merge tag 'soc-drivers-6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2023-02-27T18:04:49Z

Pull ARM SoC driver updates from Arnd Bergmann: "As usual, there are lots of minor driver changes across SoC platforms from NXP, Amlogic, AMD Zynq, Mediatek, Qualcomm, Apple and Samsung. These usually add support for additional chip variations in existing drivers, but also add features or bugfixes. The SCMI firmware subsystem gains a unified raw userspace interface through debugfs, which can be used for validation purposes. Newly added drivers include: - New power management drivers for StarFive JH7110, Allwinner D1 and Renesas RZ/V2M - A driver for Qualcomm battery and power supply status - A SoC device driver for identifying Nuvoton WPCM450 chips - A regulator coupler driver for Mediatek MT81xxv" * tag 'soc-drivers-6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (165 commits) power: supply: Introduce Qualcomm PMIC GLINK power supply soc: apple: rtkit: Do not copy the reg state structure to the stack soc: sunxi: SUN20I_PPU should depend on PM memory: renesas-rpc-if: Remove redundant division of dummy soc: qcom: socinfo: Add IDs for IPQ5332 and its variant dt-bindings: arm: qcom,ids: Add IDs for IPQ5332 and its variant dt-bindings: power: qcom,rpmpd: add RPMH_REGULATOR_LEVEL_LOW_SVS_L1 firmware: qcom_scm: Move qcom_scm.h to include/linux/firmware/qcom/ MAINTAINERS: Update qcom CPR maintainer entry dt-bindings: firmware: document Qualcomm SM8550 SCM dt-bindings: firmware: qcom,scm: add qcom,scm-sa8775p compatible soc: qcom: socinfo: Add Soc IDs for IPQ8064 and variants dt-bindings: arm: qcom,ids: Add Soc IDs for IPQ8064 and variants soc: qcom: socinfo: Add support for new field in revision 17 soc: qcom: smd-rpm: Add IPQ9574 compatible soc: qcom: pmic_glink: remove redundant calculation of svid soc: qcom: stats: Populate all subsystem debugfs files dt-bindings: soc: qcom,rpmh-rsc: Update to allow for generic nodes soc: qcom: pmic_glink: add CONFIG_NET/CONFIG_OF dependencies soc: qcom: pmic_glink: Introduce altmode support ...

Merge tag 'for-v6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/sre/linux-power-supply

2023-02-25T01:04:23Z

Pull power supply and reset updates from Sebastian Reichel: "Nothing special for the power-supply subystem this time. - power-supply core: remove faulty cooling logic - convert all sysfs show() handlers from *printf() use sysfs_emit() - bq25890: add dual-charger support required by Lenovo Yoga Tab 3 Pro - bq27xxx: fix reporting critical level - syscon-reboot: add priority property support - new rt9467 charger driver - new rt9471 charger driver - new Odroid Go Ultra poweroff driver - misc minor fixes and cleanups" * tag 'for-v6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/sre/linux-power-supply: (32 commits) power: reset: odroid-go-ultra: fix I2C dependency power: supply: leds: explicitly include linux/leds.h dt-bindings: power: supply: pm8941-coincell: Don't require charging properties dt-bindings: power: supply: pm8941-coincell: Add PM8998 compatible power: reset: add Odroid Go Ultra poweroff driver power: supply: rt9467: Fix spelling mistake "attache" -> "attach" power: supply: rt9471: fix using wrong ce_gpio in rt9471_probe() power: supply: max77650: Make max77650_charger_disable() return void Documentation: power: rt9467: Document exported sysfs entries power: supply: rt9467: Add Richtek RT9467 charger driver dt-bindings: power: supply: Add Richtek RT9467 battery charger Documentation: power: rt9471: Document exported sysfs entries power: supply: rt9471: Add Richtek RT9471 charger driver dt-bindings: power: supply: Add Richtek RT9471 battery charger power: supply: max1721x: Use strscpy() is more robust and safer power: supply: test-power: use strscpy() instead of strncpy() power: supply: bq27xxx: fix reporting critical level power: supply: bq256xx: Init ichg/vbat value with chip default value power: supply: collie_battery: Convert to GPIO descriptors (part 2) power: supply: remove faulty cooling logic ...

power: supply: Introduce Qualcomm PMIC GLINK power supply

2023-02-13T21:45:37Z

The PMIC GLINK service, running on a coprocessor of modern Qualcomm platforms, deals with battery charging and fuel gauging, as well as reporting status of AC and wireless power supplies. As this is just one of the functionalities provided by the PMIC GLINK service, this power supply driver is implemented as an auxilirary bus driver, spawned by the main "pmic glink" driver when the PMIC GLINK service is detected. Signed-off-by: Bjorn Andersson Tested-by: Konrad Dybcio # SM8350 PDX215 Reviewed-by: Neil Armstrong Tested-by: Neil Armstrong # on SM8550-MTP & SM8450-HDK Signed-off-by: Bjorn Andersson Acked-by: Sebastian Reichel Signed-off-by: Bjorn Andersson Link: https://lore.kernel.org/r/20230207144241.1767973-1-quic_bjorande@quicinc.com

power: supply: rt9467: Add Richtek RT9467 charger driver

2023-02-03T16:08:28Z

RT9467 is a switch-mode single cell Li-Ion/Li-Polymer battery charger for portable applications. It integrates a synchronous PWM controller, power MOSFETs, input current sensing and regulation, high-accuracy voltage regulation, and charge termination. The charge current is regulated through integrated sensing resistors. The RT9467 also features USB On-The-Go (OTG) support. It also integrates D+/D- pin for USB host/charging port detection. Co-developed-by: ChiYuan Huang Signed-off-by: ChiYuan Huang Signed-off-by: ChiaEn Wu Signed-off-by: Sebastian Reichel

power: supply: rt9471: Add Richtek RT9471 charger driver

2023-02-03T13:35:18Z

Add support for the RT9471 3A 1-Cell Li+ battery charger. The RT9471 is a highly-integrated 3A switch mode battery charger with low impedance power path to better optimize the charging efficiency. Co-developed-by: Alina Yu Signed-off-by: Alina Yu Signed-off-by: ChiYuan Huang Signed-off-by: Sebastian Reichel

power: remove pda_power supply driver

2023-02-01T16:23:38Z

This driver was used for a couple of Intel PXA and Samsung S3C24xx based PDAs, but all of those are now removed from the kernel, so the driver itself is no longer useful. Cc: Anton Vorontsov Cc: linux-pm@vger.kernel.org Acked-by: Sebastian Reichel Acked-by: Robert Jarzmik Signed-off-by: Arnd Bergmann

power: remove tosa_battery driver

2023-01-20T10:24:17Z

The PXA tosa machine is removed, so this driver is no longer in use. Cc: linux-pm@vger.kernel.org Acked-by: Sebastian Reichel Acked-by: Robert Jarzmik Signed-off-by: Arnd Bergmann

power: remove z2_battery driver

2023-01-20T10:24:13Z

The PXA z2 platform is gone, and this driver is now orphaned. Cc: linux-pm@vger.kernel.org Cc: Peter Edwards Acked-by: Sebastian Reichel Acked-by: Robert Jarzmik Signed-off-by: Arnd Bergmann

power: remove s3c adc battery driver

2023-01-16T08:26:05Z

The s3c-adc driver is removed along with the s3c24xx platform, so the battery driver is no longer needed either. Reviewed-by: Krzysztof Kozlowski Acked-by: Sebastian Reichel Signed-off-by: Arnd Bergmann

Merge tag 'for-v6.1' of git://git.kernel.org/pub/scm/linux/kernel/git/sre/linux-power-supply

2022-10-07T18:48:30Z

Pull power supply and reset updates from Sebastian Reichel: - new maintenance charging documentation - mt6370: new charger driver - bq25890: support input current limit - added Qualcomm PMK8350 PON support - misc minor fixes * tag 'for-v6.1' of git://git.kernel.org/pub/scm/linux/kernel/git/sre/linux-power-supply: (22 commits) power: supply: ab8500: remove unused static local variable power: supply: mt6370: Fix return value check in mt6370_chg_probe() power: supply: ab8500: Remove unused struct ab8500_chargalg_sysfs_entry power: supply: mt6370: uses IIO interfaces, depends on IIO power: supply: max1721x: Fix spelling mistake "Gauage" -> "Gauge" power: supply: mt6370: Add MediaTek MT6370 charger driver dt-bindings: power: supply: Add MediaTek MT6370 Charger lib: add linear range index macro power: supply: bq25890: Fix enum conversion in bq25890_power_supply_set_property() power: supply: bq27xxx: fix NULL vs 0 warnings power: supply: bq27xxx: fix __be16 warnings power: supply: bq25890: Add support for setting IINLIM power: supply: bq25890: Disable PUMPX_EN on errors power: supply: Fix repeated word in comments power: supply: adp5061: show unknown capacity_level as text power: supply: adp5061: fix out-of-bounds read in adp5061_get_chg_type() power: supply: tps65217: Fix comments typo power: reset: qcom-pon: add support for qcom,pmk8350-pon compatible string dt-bindings: power: reset: qcom-pon: Add new compatible "qcom,pmk8350-pon" power: supply: cw2015: Use device managed API to simplify the code ...