kernel.git/drivers/pinctrl/samsung, branch linux-4.4.y

pinctrl: samsung: Save/restore eint_mask over suspend for EINT_TYPE GPIOs

2020-06-20T08:23:24Z

commit f354157a7d184db430c1a564c506434e33b1bec5 upstream. Currently, for EINT_TYPE GPIOs, the CON and FLTCON registers are saved and restored over a suspend/resume cycle. However, the EINT_MASK registers are not. On S5PV210 at the very least, these registers are not retained over suspend, leading to the interrupts remaining masked upon resume and therefore no interrupts being triggered for the device. There should be no effect on any SoCs that do retain these registers as theoretically we would just be re-writing what was already there. Fixes: 7ccbc60cd9c2 ("pinctrl: exynos: Handle suspend/resume of GPIO EINT registers") Cc: Signed-off-by: Jonathan Bakker Signed-off-by: Krzysztof Kozlowski Signed-off-by: Greg Kroah-Hartman

pinctrl: samsung: Fix device node refcount leaks in S3C64xx wakeup controller init

2019-12-21T09:35:34Z

[ Upstream commit 7f028caadf6c37580d0f59c6c094ed09afc04062 ] In s3c64xx_eint_eint0_init() the for_each_child_of_node() loop is used with a break to find a matching child node. Although each iteration of for_each_child_of_node puts the previous node, but early exit from loop misses it. This leads to leak of device node. Cc: Fixes: 61dd72613177 ("pinctrl: Add pinctrl-s3c64xx driver") Signed-off-by: Krzysztof Kozlowski Signed-off-by: Sasha Levin

pinctrl: samsung: Fix device node refcount leaks in init code

2019-12-21T09:35:28Z

commit a322b3377f4bac32aa25fb1acb9e7afbbbbd0137 upstream. Several functions use for_each_child_of_node() loop with a break to find a matching child node. Although each iteration of for_each_child_of_node puts the previous node, but early exit from loop misses it. This leads to leak of device node. Cc: Fixes: 9a2c1c3b91aa ("pinctrl: samsung: Allow grouping multiple pinmux/pinconf nodes") Signed-off-by: Krzysztof Kozlowski Signed-off-by: Greg Kroah-Hartman

pinctrl: samsung: Fix device node refcount leaks in S3C24xx wakeup controller init

2019-12-21T09:35:28Z

commit 6fbbcb050802d6ea109f387e961b1dbcc3a80c96 upstream. In s3c24xx_eint_init() the for_each_child_of_node() loop is used with a break to find a matching child node. Although each iteration of for_each_child_of_node puts the previous node, but early exit from loop misses it. This leads to leak of device node. Cc: Fixes: af99a7507469 ("pinctrl: Add pinctrl-s3c24xx driver") Signed-off-by: Krzysztof Kozlowski Signed-off-by: Greg Kroah-Hartman

pinctrl: samsung: Remove bogus irq_[un]mask from resource management

2017-08-16T20:40:30Z

commit 3fa53ec2ed885b0aec3f0472e3b4a8a6f1cd748c upstream. The irq chip callbacks irq_request/release_resources() have absolutely no business with masking and unmasking the irq. The core code unmasks the interrupt after complete setup and masks it before invoking irq_release_resources(). The unmask is actually harmful as it happens before the interrupt is completely initialized in __setup_irq(). Remove it. Fixes: f6a8249f9e55 ("pinctrl: exynos: Lock GPIOs as interrupts when used as EINTs") Signed-off-by: Thomas Gleixner Cc: Krzysztof Kozlowski Cc: Sylwester Nawrocki Cc: Linus Walleij Cc: Kukjin Kim Cc: linux-arm-kernel@lists.infradead.org Cc: linux-samsung-soc@vger.kernel.org Cc: linux-gpio@vger.kernel.org Acked-by: Tomasz Figa Signed-off-by: Linus Walleij Signed-off-by: Greg Kroah-Hartman

pinctrl: exynos5440: Use off-stack memory for pinctrl_gpio_range

2016-06-08T01:14:35Z

commit 71324fdc72ef0163e57631aa814a9a81e9e4770b upstream. The range is registered into a linked list which can be referenced throughout the lifetime of the driver. Ensure the range's memory is useful for the same lifetime by adding it to the driver's private data structure. The bug was introduced in the driver's initial commit, which was present in v3.10. Fixes: f0b9a7e521fa ("pinctrl: exynos5440: add pinctrl driver for Samsung EXYNOS5440 SoC") Signed-off-by: Andrew Jeffery Acked-by: Tomasz Figa Reviewed-by: Krzysztof Kozlowski Signed-off-by: Linus Walleij Signed-off-by: Greg Kroah-Hartman

Merge tag 'gpio-v4.4-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio

2015-11-02T20:59:12Z

Pull GPIO updates from Linus Walleij: "Here is the bulk of GPIO changes for the v4.4 development cycle. The only changes hitting outside drivers/gpio are in the pin control subsystem and these seem to have settled nicely in linux-next. Development mistakes and catfights are nicely documented in the reverts as you can see. The outcome of the ABI fight is that we're working on a chardev ABI for GPIO now, where hope to show results for the v4.5 kernel. Summary of changes: GPIO core: - Define and handle flags for open drain/open collector and open source/open emitter, also know as "single-ended" configurations. - Generic request/free operations that handle calling out to the (optional) pin control backend. - Some refactoring related to an ABI change that did not happen, yet provide useful. - Added a real-time compliance checklist. Many GPIO chips have irqchips, and need to think this over with the RT patches going upstream. - Restructure, fix and clean up Kconfig menus a bit. New drivers: - New driver for AMD Promony. - New driver for ACCES 104-IDIO-16, a port-mapped I/O card, ISA-style. Very retro. Subdriver changes: - OMAP changes to handle real time requirements. - Handle trigger types for edge and level IRQs on PL061 properly. As this hardware is very common it needs to set a proper example for others to follow. - Some container_of() cleanups. - Delete the unused MSM driver in favor of the driver that is embedded inside the pin control driver. - Cleanup of the ath79 GPIO driver used by many, many OpenWRT router targets. - A consolidated IT87xx driver replacing the earlier very specific IT8761e driver. - Handle the TI TCA9539 in the PCA953x driver. Also handle ACPI devices in this subdriver. - Drop xilinx arch dependencies as these FPGAs seem to profilate over a few different architectures. MIPS and ARM come to mind" * tag 'gpio-v4.4-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio: (57 commits) gpio: fix up SPI submenu gpio: drop surplus I2C dependencies gpio: drop surplus X86 dependencies gpio: dt-bindings: document the official use of "ngpios" gpio: MAINTAINERS: Add an entry for the ATH79 GPIO driver gpio / ACPI: Allow shared GPIO event to be read via operation region gpio: group port-mapped I/O drivers in a menu gpio: Add ACCES 104-IDIO-16 driver maintainer entry gpio: zynq: Document interrupt-controller DT binding gpio: xilinx: Drop architecture dependencies gpio: generic: Revert to old error handling in bgpio_map gpio: add a real time compliance notes Revert "gpio: add a real time compliance checklist" gpio: Add GPIO support for the ACCES 104-IDIO-16 gpio: driver for AMD Promontory gpio: xlp: Convert to use gpiolib irqchip helpers gpio: add a real time compliance checklist gpio/xilinx: enable for MIPS gpiolib: Add and use OF_GPIO_SINGLE_ENDED flag gpiolib: Split GPIO flags parsing and GPIO configuration ...

pinctrl: replace trivial implementations of gpio_chip request/free

2015-10-16T20:20:21Z

Replace all trivial request/free callbacks that do nothing but call into pinctrl code with the generic versions. Signed-off-by: Jonas Gorski Acked-by: Bjorn Andersson Acked-by: Heiko Stuebner Acked-by: Eric Anholt Acked-by: Mika Westerberg Acked-by: Andrew Bresticker Acked-by: Baruch Siach Acked-by: Matthias Brugger Acked-by: Lee Jones Acked-by: Laxman Dewangan Acked-by: Maxime Ripard Signed-off-by: Linus Walleij

pinctrl: samsung: Remove unneded semicolon

2015-10-02T11:06:48Z

It's not needed an is just creating a null statement, so remove it. Signed-off-by: Javier Martinez Canillas Reviewed-by: Krzysztof Kozlowski Signed-off-by: Linus Walleij

Merge branch 'irq-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip

2015-09-18T15:11:42Z

Pull irq updates from Thomas Gleixner: "This is a rather large update post rc1 due to the final steps of cleanups and API changes which had to wait for the preparatory patches to hit your tree. - Regression fixes for ARM GIC irqchips - Regression fixes and lockdep anotations for renesas irq chips - The leftovers of the cleanup and preparatory patches which have been ignored by maintainers - Final conversions of the newly merged users of obsolete APIs - Final removal of obsolete APIs - Final removal of ARM artifacts which had been introduced during the conversion of ARM to the generic interrupt code. - Final split of the irq_data into chip specific and common data to reflect the needs of hierarchical irq domains. - Treewide removal of the first argument of interrupt flow handlers, i.e. the irq number, which is not used by the majority of handlers and simple to retrieve from the other argument the irq descriptor. - A few comment updates and build warning fixes" * 'irq-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip: (40 commits) arm64: Remove ununsed set_irq_flags ARM: Remove ununsed set_irq_flags sh: Kill off set_irq_flags usage irqchip: Kill off set_irq_flags usage gpu/drm: Kill off set_irq_flags usage genirq: Remove irq argument from irq flow handlers genirq: Move field 'msi_desc' from irq_data into irq_common_data genirq: Move field 'affinity' from irq_data into irq_common_data genirq: Move field 'handler_data' from irq_data into irq_common_data genirq: Move field 'node' from irq_data into irq_common_data irqchip/gic-v3: Use IRQD_FORWARDED_TO_VCPU flag irqchip/gic: Use IRQD_FORWARDED_TO_VCPU flag genirq: Provide IRQD_FORWARDED_TO_VCPU status flag genirq: Simplify irq_data_to_desc() genirq: Remove __irq_set_handler_locked() pinctrl/pistachio: Use irq_set_handler_locked gpio: vf610: Use irq_set_handler_locked powerpc/mpc8xx: Use irq_set_handler_locked() powerpc/ipic: Use irq_set_handler_locked() powerpc/cpm2: Use irq_set_handler_locked() ...