kernel.git/drivers/net/ethernet/intel/igb, branch linux-5.18.y

igb: Make DMA faster when CPU is active on the PCIe link

2022-06-29T07:04:34Z

[ Upstream commit 4e0effd9007ea0be31f7488611eb3824b4541554 ] Intel I210 on some Intel Alder Lake platforms can only achieve ~750Mbps Tx speed via iperf. The RR2DCDELAY shows around 0x2xxx DMA delay, which will be significantly lower when 1) ASPM is disabled or 2) SoC package c-state stays above PC3. When the RR2DCDELAY is around 0x1xxx the Tx speed can reach to ~950Mbps. According to the I210 datasheet "8.26.1 PCIe Misc. Register - PCIEMISC", "DMA Idle Indication" doesn't seem to tie to DMA coalesce anymore, so set it to 1b for "DMA is considered idle when there is no Rx or Tx AND when there are no TLPs indicating that CPU is active detected on the PCIe link (such as the host executes CSR or Configuration register read or write operation)" and performing Tx should also fall under "active CPU on PCIe link" case. In addition to that, commit b6e0c419f040 ("igb: Move DMA Coalescing init code to separate function.") seems to wrongly changed from enabling E1000_PCIEMISC_LX_DECISION to disabling it, also fix that. Fixes: b6e0c419f040 ("igb: Move DMA Coalescing init code to separate function.") Signed-off-by: Kai-Heng Feng Tested-by: Gurucharan (A Contingent worker at Intel) Signed-off-by: Tony Nguyen Link: https://lore.kernel.org/r/20220621221056.604304-1-anthony.l.nguyen@intel.com Signed-off-by: Jakub Kicinski Signed-off-by: Sasha Levin

igb: fix a use-after-free issue in igb_clean_tx_ring

2022-06-29T07:04:31Z

[ Upstream commit 3f6a57ee8544ec3982f8a3cbcbf4aea7d47eb9ec ] Fix the following use-after-free bug in igb_clean_tx_ring routine when the NIC is running in XDP mode. The issue can be triggered redirecting traffic into the igb NIC and then closing the device while the traffic is flowing. [ 73.322719] CPU: 1 PID: 487 Comm: xdp_redirect Not tainted 5.18.3-apu2 #9 [ 73.330639] Hardware name: PC Engines APU2/APU2, BIOS 4.0.7 02/28/2017 [ 73.337434] RIP: 0010:refcount_warn_saturate+0xa7/0xf0 [ 73.362283] RSP: 0018:ffffc9000081f798 EFLAGS: 00010282 [ 73.367761] RAX: 0000000000000000 RBX: ffffc90000420f80 RCX: 0000000000000000 [ 73.375200] RDX: ffff88811ad22d00 RSI: ffff88811ad171e0 RDI: ffff88811ad171e0 [ 73.382590] RBP: 0000000000000900 R08: ffffffff82298f28 R09: 0000000000000058 [ 73.390008] R10: 0000000000000219 R11: ffffffff82280f40 R12: 0000000000000090 [ 73.397356] R13: ffff888102343a40 R14: ffff88810359e0e4 R15: 0000000000000000 [ 73.404806] FS: 00007ff38d31d740(0000) GS:ffff88811ad00000(0000) knlGS:0000000000000000 [ 73.413129] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 [ 73.419096] CR2: 000055cff35f13f8 CR3: 0000000106391000 CR4: 00000000000406e0 [ 73.426565] Call Trace: [ 73.429087] [ 73.431314] igb_clean_tx_ring+0x43/0x140 [igb] [ 73.436002] igb_down+0x1d7/0x220 [igb] [ 73.439974] __igb_close+0x3c/0x120 [igb] [ 73.444118] igb_xdp+0x10c/0x150 [igb] [ 73.447983] ? igb_pci_sriov_configure+0x70/0x70 [igb] [ 73.453362] dev_xdp_install+0xda/0x110 [ 73.457371] dev_xdp_attach+0x1da/0x550 [ 73.461369] do_setlink+0xfd0/0x10f0 [ 73.465166] ? __nla_validate_parse+0x89/0xc70 [ 73.469714] rtnl_setlink+0x11a/0x1e0 [ 73.473547] rtnetlink_rcv_msg+0x145/0x3d0 [ 73.477709] ? rtnl_calcit.isra.0+0x130/0x130 [ 73.482258] netlink_rcv_skb+0x8d/0x110 [ 73.486229] netlink_unicast+0x230/0x340 [ 73.490317] netlink_sendmsg+0x215/0x470 [ 73.494395] __sys_sendto+0x179/0x190 [ 73.498268] ? move_addr_to_user+0x37/0x70 [ 73.502547] ? __sys_getsockname+0x84/0xe0 [ 73.506853] ? netlink_setsockopt+0x1c1/0x4a0 [ 73.511349] ? __sys_setsockopt+0xc8/0x1d0 [ 73.515636] __x64_sys_sendto+0x20/0x30 [ 73.519603] do_syscall_64+0x3b/0x80 [ 73.523399] entry_SYSCALL_64_after_hwframe+0x44/0xae [ 73.528712] RIP: 0033:0x7ff38d41f20c [ 73.551866] RSP: 002b:00007fff3b945a68 EFLAGS: 00000246 ORIG_RAX: 000000000000002c [ 73.559640] RAX: ffffffffffffffda RBX: 0000000000000000 RCX: 00007ff38d41f20c [ 73.567066] RDX: 0000000000000034 RSI: 00007fff3b945b30 RDI: 0000000000000003 [ 73.574457] RBP: 0000000000000003 R08: 0000000000000000 R09: 0000000000000000 [ 73.581852] R10: 0000000000000000 R11: 0000000000000246 R12: 00007fff3b945ab0 [ 73.589179] R13: 0000000000000000 R14: 0000000000000003 R15: 00007fff3b945b30 [ 73.596545] [ 73.598842] ---[ end trace 0000000000000000 ]--- Fixes: 9cbc948b5a20c ("igb: add XDP support") Signed-off-by: Lorenzo Bianconi Reviewed-by: Jesse Brandeburg Acked-by: Jesper Dangaard Brouer Link: https://lore.kernel.org/r/e5c01d549dc37bff18e46aeabd6fb28a7bcf84be.1655388571.git.lorenzo@kernel.org Signed-off-by: Jakub Kicinski Signed-off-by: Sasha Levin

igb: skip phy status check where unavailable

2022-05-18T13:00:51Z

igb_read_phy_reg() will silently return, leaving phy_data untouched, if hw->ops.read_reg isn't set. Depending on the uninitialized value of phy_data, this led to the phy status check either succeeding immediately or looping continuously for 2 seconds before emitting a noisy err-level timeout. This message went out to the console even though there was no actual problem. Instead, first check if there is read_reg function pointer. If not, proceed without trying to check the phy status register. Fixes: b72f3f72005d ("igb: When GbE link up, wait for Remote receiver status condition") Signed-off-by: Kevin Mitchell Tested-by: Gurucharan (A Contingent worker at Intel) Signed-off-by: Tony Nguyen Signed-off-by: David S. Miller

igb: zero hwtstamp by default

2022-03-17T15:32:28Z

Clang static analysis reports this representative issue igb_ptp.c:997:3: warning: The left operand of '+' is a garbage value ktime_add_ns(shhwtstamps.hwtstamp, adjust); ^ ~~~~~~~~~~~~~~~~~~~~ shhwtstamps.hwtstamp is set by a call to igb_ptp_systim_to_hwtstamp(). In the switch-statement for the hw type, the hwtstamp is zeroed for matches but not the default case. Move the memset out of switch-statement. This degarbages the default case and reduces the size. Some whitespace cleanup of empty lines Signed-off-by: Tom Rix Tested-by: Gurucharan G (A Contingent worker at Intel) Signed-off-by: Tony Nguyen

igb: refactor XDP registration

2022-02-07T22:23:01Z

On changing the RX ring parameters igb uses a hack to avoid a warning when calling xdp_rxq_info_reg via igb_setup_rx_resources. It just clears the struct xdp_rxq_info content. Instead, change this to unregister if we're already registered. Align code to the igc code. Fixes: 9cbc948b5a20c ("igb: add XDP support") Signed-off-by: Corinna Vinschen Acked-by: Vinicius Costa Gomes Tested-by: Sandeep Penigalapati Signed-off-by: Tony Nguyen

igb: Remove useless DMA-32 fallback configuration

2022-01-27T16:58:24Z

As stated in [1], dma_set_mask() with a 64-bit mask never fails if dev->dma_mask is non-NULL. So, if it fails, the 32 bits case will also fail for the same reason. So, if dma_set_mask_and_coherent() succeeds, 'pci_using_dac' is known to be 1. Simplify code and remove some dead code accordingly. [1]: https://lkml.org/lkml/2021/6/7/398 Signed-off-by: Christophe JAILLET Tested-by: Gurucharan G Signed-off-by: Tony Nguyen

Merge git://git.kernel.org/pub/scm/linux/kernel/git/bpf/bpf-next

2021-12-31T14:35:40Z

Alexei Starovoitov says: ==================== pull-request: bpf-next 2021-12-30 The following pull-request contains BPF updates for your *net-next* tree. We've added 72 non-merge commits during the last 20 day(s) which contain a total of 223 files changed, 3510 insertions(+), 1591 deletions(-). The main changes are: 1) Automatic setrlimit in libbpf when bpf is memcg's in the kernel, from Andrii. 2) Beautify and de-verbose verifier logs, from Christy. 3) Composable verifier types, from Hao. 4) bpf_strncmp helper, from Hou. 5) bpf.h header dependency cleanup, from Jakub. 6) get_func_[arg|ret|arg_cnt] helpers, from Jiri. 7) Sleepable local storage, from KP. 8) Extend kfunc with PTR_TO_CTX, PTR_TO_MEM argument support, from Kumar. ==================== Signed-off-by: David S. Miller

igb: support EXTTS on 82580/i354/i350

2021-12-29T18:01:04Z

Support for the PTP pin function on 82580/i354/i350 based adapters. Because the time registers of these adapters do not have the nice split in second rollovers as the i210 has, the implementation is slightly more complex compared to the i210 implementation. Signed-off-by: Ruud Bos Tested-by: Gurucharan G Signed-off-by: Tony Nguyen

igb: support PEROUT on 82580/i354/i350

2021-12-29T18:01:04Z

Support for the PEROUT PTP pin function on 82580/i354/i350 based adapters. Because the time registers of these adapters do not have the nice split in second rollovers as the i210 has, the implementation is slightly more complex compared to the i210 implementation. Signed-off-by: Ruud Bos Tested-by: Gurucharan G Signed-off-by: Tony Nguyen

igb: move PEROUT and EXTTS isr logic to separate functions

2021-12-29T18:01:03Z

Remove code duplication in the tsync interrupt handler function by moving this logic to separate functions. This keeps the interrupt handler readable and allows the new functions to be extended for adapter types other than i210. Signed-off-by: Ruud Bos Tested-by: Gurucharan G Signed-off-by: Tony Nguyen