kernel.git/drivers/net/ethernet/intel/igb, branch linux-3.17.y

igb: bump igb version to 5.2.13

2014-07-24T10:11:19Z

Bump version number. Signed-off-by: Todd Fujinaka Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher

igb: Add message when malformed packets detected by hw

2014-07-24T10:00:37Z

This patch adds a check and prints the error cause register value when the hardware detects a malformed packet. This is a very unlikely scenario but has been seen occasionally, so printing the message to assist the user. Signed-off-by: Carolyn Wyborny Signed-off-by: Jeff Kirsher

igb: remove unnecessary break after return

2014-07-21T04:30:18Z

Signed-off-by: Fabian Frederick Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2014-07-16T21:09:34Z

Signed-off-by: David S. Miller

igb: remove unnecessary break after goto

2014-07-14T06:45:24Z

Signed-off-by: Fabian Frederick Signed-off-by: David S. Miller

igb: do a reset on SR-IOV re-init if device is down

2014-07-10T19:45:24Z

To properly re-initialize SR-IOV it is necessary to reset the device even if it is already down. Not doing this may result in Tx unit hangs. Cc: stable Signed-off-by: Stefan Assmann Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher Signed-off-by: David S. Miller

igb: Workaround for i210 Errata 25: Slow System Clock

2014-07-10T08:48:28Z

On some devices, the internal PLL circuit occasionally provides the wrong clock frequency after power up. The probability of failure is less than one failure per 1000 power cycles. When the failure occurs, the internal clock frequency is around 1/20 of the correct frequency. Cc: stable Signed-off-by: Todd Fujinaka Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher Signed-off-by: David S. Miller

igb: bring link up when PHY is powered up

2014-07-01T09:39:54Z

Call igb_setup_link() when the PHY is powered up. Signed-off-by: Todd Fujinaka Reported-by: Jeff Westfahl Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher

igb: separate hardware setting from the set_ts_config ioctl

2014-06-11T15:45:55Z

This patch separates the hardware logic from the set function, so that we can re-use it during a ptp_reset. This enables the reset to return functionality to the last known timestamp mode, rather than resetting the value. We initialize the mode to off during the ptp_init cycle. Signed-off-by: Jacob Keller Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher

igb: unhide invariant returns

2014-06-11T15:45:48Z

Return a 0 directly rather than a constant. Reported-by: Peter Senna Tschudin Signed-off-by: Todd Fujinaka Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher