kernel.git/drivers/media/i2c/Makefile, branch linux-4.5.y

[media] cs3308: add new 8-channel volume control driver

2015-12-18T15:35:51Z

Add simple support for this 8 channel volume control driver. Currently all it does is to unmute all 8 channels. Based upon Devin's initial patch made for an older kernel which I cleaned up and rebased. Thanks to Kernel Labs for that work. Signed-off-by: Devin Heitmueller Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab

[media] Driver for Toshiba TC358743 HDMI to CSI-2 bridge

2015-07-17T12:59:28Z

The driver is tested on our hardware and all the implemented features works as expected. Missing features: - CEC support - HDCP repeater support - IR support Signed-off-by: Mats Randgaard [hans.verkuil@cisco.com: updated copyright year to 2015] [hans.verkuil@cisco.com: update confusing confctl_mutex comment] Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab

[media] media: i2c: add support for omnivision's ov2659 sensor

2015-04-03T01:15:46Z

this patch adds support for omnivision's ov2659 sensor, the driver supports following features: 1: Asynchronous probing 2: DT support 3: Media controller support Signed-off-by: Benoit Parrot Signed-off-by: Lad, Prabhakar Acked-by: Sakari Ailus Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab

[media] vino/saa7191: move to staging in preparation for removal

2014-12-17T01:21:42Z

These drivers haven't been tested in a long, long time. The hardware is ancient and hopelessly obsolete. These drivers also need to be converted to newer media frameworks but due to the lack of hardware that's going to be impossible. So these drivers are a prime candidate for removal. If someone is interested in working on these drivers to prevent their removal, then please contact the linux-media mailinglist. Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab

[media] V4L: Add driver for s5k6a3 image sensor

2014-03-14T13:32:17Z

This patch adds subdev driver for Samsung S5K6A3 raw image sensor. As it is intended at the moment to be used only with the Exynos FIMC-IS (camera ISP) subsystem it is pretty minimal subdev driver. It doesn't do any I2C communication since the sensor is controlled by the ISP and its own firmware. This driver, if needed, can be updated in future into a regular subdev driver where the main CPU communicates with the sensor directly. Signed-off-by: Sylwester Nawrocki Acked-by: Kyungmin Park Signed-off-by: Mauro Carvalho Chehab

[media] lm3646: add new dual LED Flash driver

2014-03-11T13:00:26Z

This patch adds the driver for the LM3646, dual LED Flash driver. The LM3646 has two 1.5A sync. boost converter with dual white current source. It is controlled via an I2C compatible interface. Each flash brightness, torch brightness and enable/disable can be controlled. Under voltage, input voltage monitor and thermal threshhold Faults are added. Please refer the datasheet http://www.ti.com/lit/ds/snvs962/snvs962.pdf Signed-off-by: Daniel Jeong Signed-off-by: Sakari Ailus Signed-off-by: Mauro Carvalho Chehab

[media] saa6752hs: move to media/i2c

2014-01-07T09:39:17Z

This driver is independent from saa7134, so there is no reason why this shouldn't be in media/i2c like all other i2c media drivers. Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab

[media] Add driver for Samsung S5K5BAF camera sensor

2013-12-21T09:01:36Z

Driver for Samsung S5K5BAF UXGA 1/5" 2M CMOS Image Sensor with embedded SoC ISP. The device is exposed as two V4L2 subdevices: - S5K5BAF-CIS - the image sensor matrix, fixed 1600x1200 format, no controls. - S5K5BAF-ISP - the Image Signal Processor, formats up to 1600x1200, pre/post ISP cropping, downscaling via selection API, controls. [m.chehab@samsung.com: Whitespace cleanups] Signed-off-by: Sylwester Nawrocki Signed-off-by: Andrzej Hajda Signed-off-by: Kyungmin Park Signed-off-by: Mauro Carvalho Chehab

[media] omap24xx/tcm825x: move to staging for future removal

2013-12-20T15:45:22Z

The omap24xx driver and the tcm825x sensor driver are the only two remaining drivers to still use the old deprecated v4l2-int-device API. Nobody maintains these drivers anymore. But unfortunately the v4l2-int-device API is used by out-of-tree drivers (MXC platform). This is a very bad situation since as long as this deprecated API stays in the kernel there is no reason for those out-of-tree drivers to convert. This patch moves v4l2-int-device and the two drivers that depend on it to staging in preparation for their removal. If someone would be interested in getting these drivers to work, then start with this since it's not very far from the state where they used to work: The branch is n800-cam. Porting to up-to-date APIs can then be done. David might have done some work in that area, so check with him first. Signed-off-by: Hans Verkuil Cc: Sakari Ailus Cc: David Cohen Signed-off-by: Mauro Carvalho Chehab

[media] media: i2c: add driver for dual LED Flash, lm3560

2013-10-31T08:36:39Z

Adds the driver for the LM3560, dual LED Flash The LM3560 has two 1A constant current driver for high current white LEDs. It is controlled via an I2C compatible interface(up to 400kHz). Each flash brightness, torch brightness and enable/disable can be controlled independantly, but flash timeout and operation mode are shared. Signed-off-by: Daniel Jeong Signed-off-by: Mauro Carvalho Chehab