kernel.git/drivers/iio/proximity, branch linux-4.13.y

Merge tag 'iio-for-4.13b' of git://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio into staging-next

2017-06-26T05:09:23Z

Jonathan writes: Second set of IIO new device support, features and cleanups for the 4.13 cycle. A few reverts here. One was a general failure to notice a device was already supported by another driver. The second is due to a review comment pointing out that the original patch was a bad idea and would break existing systems. Reverts * bma180 - Revert addition of support for the BMA250E it is already supported by the bmc150-accel and better supported at that. Oops. * hi8435 - The fix for cleanup of the reset gpio stuff isn't a good way to go. It breaks systems where an inverting level convertor is used. The right fix is to make the original devicetree correct - even if it involves patching the devicetree in kernel. New Device Support * stm32-adc - STM32H7 support and bindings. Features * core - add a hardware triggered operating mode for systems in which the actual trigger is never seen by the kernel. This is typically only used when a device 'can' use other triggers, but if a particular magic one is enabled the interrupt is effectively handled in hardware and we never see it. * st-lsm6dsx - support active low interrupts. * stm32-adc - Make the core adc clock optional as not all hardware supported requires it. - Make the bus clock optional in the per instance driver as it may be shared by all instances of the ADC and is handled by the core. - Rework to have a data structure representing the device type specific elements. * stm32-trigger (and counter) - Use the INDIO_HARDWARE_TRIGGERED_MODE where appropriate. - Add an attribute to configure device modes for quadrature counting etc. Clean ups and minor fixes * IIO core. - use __sysfs_match_string() helper rather than open coding the same. * ad7791 - use sysfs_match_string() helper rather than open coding the same. * aspeed-adc - handle return value of clk_prepare_enable * cpcap - Fix default register values and ensure the battery thermistor is enabled correctly. - Fix the reported die temperature where we can - docs are lacking. - Remove the hung interrupt quirk as no longer happens due to fix in the mfd driver. * hi8435 - Remove &s from hi8435_info definition as unneeded and inconsistent. * hid-sensor-trgger - Add kconfig depends on IIO_BUFFER (fixes patch in previous series) * ina2xx - Make the use of iio_info_mask* elements consistent for all channels. This doesn't have any visible effect, but acts as clear documentation of which channels various resulting attributes apply to. * lpc32xx - handle the return value of clk_prepare_enable. * meson-saradc - NULL instead of 0 for pointer. * mma9551 - use NULL for GPIO connection ID to aid implementation fo ACPI support. Here the connection ID doesn't actually tell us anything and it is much easier to deal with the driver if it's not there. * mpu6050 - Fix lock issues through use of a local mux. - Replace sprintf with scnprintf as appropriate. - Check whoami against all known values. This allows for a small number of boards where we are really fishing for the part not being present at all. It is unfortunately common to have undescribed changes to use newer chips. We paper over this but just emitting a warning for those cases as long as we know about. * mxs-lradc - Fix some non static warnings. * rcar-adc - Part of making the naming for this part consistent across the kernel. * st_accel - drop some spi_device_id entries for variants with no SPI support * st_magn - drop some spi_device_id entries for variants with no SPI support. * sx9500 - Use devm_gpiod_get instead of indexed value with an index of 0 on all occasions. * twl4030 - Drop unused twl4030_get_madc_conversion as callers removed now throughout kernel. - Unexport twl4030_madc_conversion() as no used only within this driver. - Drop twl4030_madc_user_params as not used now. - Drop twl4030_madc_request.func_cb as not used now. - Fold the twl4030-madc.h header into the driver as no longer used anywhere else in the kernel. * xilinx - Handle the return value of clk_prepare_enable

Merge 4.12-rc5 into staging-next

2017-06-12T06:20:47Z

We want the IIO fixes and other staging driver fixes in here as well. Signed-off-by: Greg Kroah-Hartman

iio: proximity: sx9500: Use devm_gpiod_get()

2017-06-11T14:07:34Z

Since index is always 0 replace devm_gpiod_get_index() by devm_gpiod_get(). Signed-off-by: Andy Shevchenko Signed-off-by: Jonathan Cameron

iio: proximity: as3935: fix iio_trigger_poll issue

2017-05-07T12:21:55Z

Using iio_trigger_poll() can oops when multiple interrupts happen before the first is handled. Use iio_trigger_poll_chained() instead and use the timestamp when processed, since it will be in theory be 2 ms max latency. Fixes: 24ddb0e4bba4 ("iio: Add AS3935 lightning sensor support") Cc: stable@vger.kernel.org Signed-off-by: Matt Ranostay Signed-off-by: Jonathan Cameron

iio: proximity: as3935: fix AS3935_INT mask

2017-04-27T15:28:57Z

AS3935 interrupt mask has been incorrect so valid lightning events would never trigger an buffer event. Also noise interrupt should be BIT(0). Fixes: 24ddb0e4bba4 ("iio: Add AS3935 lightning sensor support") CC: stable@vger.kernel.org Signed-off-by: Matt Ranostay Signed-off-by: Jonathan Cameron

iio: proximity: as3935: move storm out of range check

2017-04-27T06:22:46Z

Move out of storm check to apply to IIO_CHAN_INFO_RAW so the reported results are constant between the former and the IIO_CHAN_INFO_PROCESSED Signed-off-by: Matt Ranostay Signed-off-by: Jonathan Cameron

iio: proximity: as3935: recalibrate RCO after resume

2017-04-26T06:06:31Z

According to the datasheet the RCO must be recalibrated on every power-on-reset. Also remove mutex locking in the calibration function since callers other than the probe function (which doesn't need it) will have a lock. Fixes: 24ddb0e4bba4 ("iio: Add AS3935 lightning sensor support") Cc: George McCollister Signed-off-by: Matt Ranostay Signed-off-by: Jonathan Cameron

Merge tag 'iio-fixes-for-4.11e' of git://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio into staging-next

2017-04-18T17:38:38Z

Jonathan writes: Fifth set of IIO fixes for the 4.11 cycle. As these are rather late in the cycle, they may sneak over into 4.12. There is a fix for a regression caused by another fix (hid sensors hardware seems to vary a lot in how various corner cases are handled). * ad7303 - fix channel description. Numeric values were being passed as characters presumably leading to garbage from the userspace interface. * as3935 - the write data macro was wrong so fix it. * bmp280 - incorrect handling of negative values as being unsigned broke humidity calculation. * hid-sensor - Restore the poll and hysteresis values after resume as some hardware doesn't do it. * stm32-trigger - buglet in reading the sampling frequency

iio: proximity: as3935: fix as3935_write

2017-04-14T13:48:58Z

AS3935_WRITE_DATA macro bit is incorrect and the actual write sequence is two leading zeros. Cc: George McCollister Signed-off-by: Matt Ranostay Cc: Signed-off-by: Jonathan Cameron

iio: proximity: as3935: constify attribute_group structures

2017-04-01T10:26:10Z

Check for attribute_group structures that are only stored in the attrs filed of iio_info structure. As the attrs field of iio_info structures is constant, so these attribute_group structures can also be declared constant. Done using coccinelle: @r1 disable optional_qualifier @ identifier i; position p; @@ static struct attribute_group i@p = {...}; @ok1@ identifier r1.i; position p; struct iio_info x; @@ x.attrs=&i@p; @bad@ position p!={r1.p,ok1.p}; identifier r1.i; @@ i@p @depends on !bad disable optional_qualifier@ identifier r1.i; @@ static +const struct attribute_group i={...}; @depends on !bad disable optional_qualifier@ identifier r1.i; @@ +const struct attribute_group i; File size before: text data bss dec hex filename 4037 288 0 4325 10e5 drivers/iio/proximity/as3935.o File size after: text data bss dec hex filename 4101 256 0 4357 1105 drivers/iio/proximity/as3935.o Signed-off-by: simran singhal Signed-off-by: Jonathan Cameron