kernel.git/drivers/hwmon/pmbus, branch linux-4.12.y

hwmon: (ucd9200) Add OF device ID table

2017-04-02T14:01:53Z

The driver doesn't have a struct of_device_id table but supported devices are registered via Device Trees. This is working on the assumption that a I2C device registered via OF will always match a legacy I2C device ID and that the MODALIAS reported will always be of the form i2c:. But this could change in the future so the correct approach is to have an OF device ID table if the devices are registered via OF. Signed-off-by: Javier Martinez Canillas Signed-off-by: Guenter Roeck

hwmon: (ucd9000) Add OF device ID table

2017-04-02T14:01:53Z

driver: (adm1275) set the m,b and R coefficients correctly for power

2017-03-28T02:43:36Z

Seems like coefficient values for m, b and R under power have been put in the wrong order. Rearranging them properly to get correct values of coefficients for power. For specs, please refer to table 7 (page 35) on http://www.analog.com/media/en/technical-documentation/data-sheets/ADM1075.pdf Fixes: 904b296f308d ("hwmon: (adm1275) Introduce configuration data structure for coeffcients") Signed-off-by: Shikhar Dogra Signed-off-by: Guenter Roeck

hwmon: (adm1275) Enable adm1278 VOUT sampling

2016-12-02T21:28:07Z

The adm1278 can optionally monitor the VOUT pin. This functionality is not enabled at reset, so PMON_CONFIG needs to be modified in order to enable it. Signed-off-by: Yi Li Signed-off-by: Joel Stanley Signed-off-by: Guenter Roeck

hwmon: (ucd9000) Add support for UCD90160 Power Supply Sequencer

2016-09-09T04:34:16Z

The UCD90160 Power Supply Sequencer reuses the existing register layout, so just an id addition was required. Signed-off-by: Matthew Weber Signed-off-by: Ronak Desai [groeck: Updated description, ordered alphabetically, added documentation] Signed-off-by: Guenter Roeck

hwmon: (pmbus) Add explicit support for DPS-460, DPS-800, and SGD009

2016-09-09T04:34:14Z

Provide support for PSU DPS-460, DPS-800 from Delta Electronics, INC and for SGD009 from Acbel Polytech, INC. These devices do not support the STATUS_CML register, and reports a communication error in response to this command. For this reason, the status register check is disabled for these controllers. Signed-off-by: Vadim Pasternak Reviewed-by: Jiri Pirko Reviewed-by: Jean Delvare Signed-off-by: Guenter Roeck

hwmon: (adm1275) Add support for ADM1278

2016-03-05T14:36:03Z

ADM1278 is mostly compatible to other chips of the same series. Besides the usual difference in coefficients, it supports a temperature sensor, and it can measure both input and output voltage at the same time. Signed-off-by: Guenter Roeck

hwmon: (pmbus) Add client driver for LTC3815

2015-12-18T16:20:59Z

LTC3815 is a Monolithic Synchronous DC/DC Step-Down Converter. Cc: Michael Jones Signed-off-by: Guenter Roeck

hwmon: (ltc2978) Add support for LTM4675

2015-08-19T16:08:55Z

LTM2975 is a dual 9A or single 18A μModule regulator. It is register compatible with LTM4676. Signed-off-by: Guenter Roeck

hwmon: (ltc2978) Add polling for chips requiring it

2015-08-19T16:08:41Z

Some of the LTC chips supported by this driver have to be polled to ensure that they are ready to accept commands. Signed-off-by: Michael Jones [Guenter Roeck: simplifications and formatting changes] Signed-off-by: Guenter Roeck