kernel.git/drivers/gpu/drm/msm/dsi, branch linux-6.4.y

drm/msm/dsi: Drop unused regulators from QCM2290 14nm DSI PHY config

2023-08-03T08:25:55Z

[ Upstream commit 97368254a08e2ca4766e7f84a45840230fe77fa3 ] The regulator setup was likely copied from other SoCs by mistake. Just like SM6125 the DSI PHY on this platform is not getting power from a regulator but from the MX power domain. Fixes: 572e9fd6d14a ("drm/msm/dsi: Add phy configuration for QCM2290") Signed-off-by: Marijn Suijten Reviewed-by: Konrad Dybcio Reviewed-by: Dmitry Baryshkov Reviewed-by: Abhinav Kumar Patchwork: https://patchwork.freedesktop.org/patch/544536/ Link: https://lore.kernel.org/r/20230627-sm6125-dpu-v2-1-03e430a2078c@somainline.org Signed-off-by: Abhinav Kumar Signed-off-by: Sasha Levin

drm/msm/dsi: Remove incorrect references to slice_count

2023-07-19T14:36:04Z

[ Upstream commit 155fa3a91d64221eb0885fd221cc8085dbef908f ] Currently, slice_count is being used to calculate word count and pkt_per_line. Instead, these values should be calculated using slice per packet, which is not the same as slice_count. Slice count represents the number of slices per interface, and its value will not always match that of slice per packet. For example, it is possible to have cases where there are multiple slices per interface but the panel specifies only one slice per packet. Thus, use the default value of one slice per packet and remove slice_count from the aforementioned calculations. Fixes: 08802f515c3c ("drm/msm/dsi: Add support for DSC configuration") Fixes: bc6b6ff8135c ("drm/msm/dsi: Use DSC slice(s) packet size to compute word count") Reviewed-by: Marijn Suijten Signed-off-by: Jessica Zhang Patchwork: https://patchwork.freedesktop.org/patch/541965/ Link: https://lore.kernel.org/r/20230405-add-dsc-support-v6-5-95eab864d1b6@quicinc.com Signed-off-by: Dmitry Baryshkov Signed-off-by: Sasha Levin

drm/msm/dsi: don't allow enabling 14nm VCO with unprogrammed rate

2023-07-19T14:35:45Z

[ Upstream commit 1e0a97f84d73ea1182740f62069690c7f3271abb ] If the dispcc uses CLK_OPS_PARENT_ENABLE (e.g. on QCM2290), CCF can try enabling VCO before the rate has been programmed. This can cause clock lockups and/or other boot issues. Program the VCO to the minimal PLL rate if the read rate is 0 Hz. Cc: Konrad Dybcio Signed-off-by: Dmitry Baryshkov Reported-by: Vladimir Zapolskiy Reported-by: Konrad Dybcio Reviewed-by: Konrad Dybcio Fixes: f079f6d999cb ("drm/msm/dsi: Add PHY/PLL for 8x96") Patchwork: https://patchwork.freedesktop.org/patch/534813/ Link: https://lore.kernel.org/r/20230501011257.3460103-1-dmitry.baryshkov@linaro.org Signed-off-by: Dmitry Baryshkov Signed-off-by: Sasha Levin

drm/msm/dsi: Remove custom DSI config handling

2023-04-06T17:29:45Z

Now that the only user is handled by common code, remove the option to specify custom handlers through match data. This is effectively a revert of commit: 5ae15e76271 ("drm/msm/dsi: Allow to specify dsi config as pdata") Reviewed-by: Dmitry Baryshkov Reviewed-by: Marijn Suijten Signed-off-by: Konrad Dybcio Patchwork: https://patchwork.freedesktop.org/patch/527662/ Link: https://lore.kernel.org/r/20230307-topic-dsi_qcm-v6-7-70e13b1214fa@linaro.org Signed-off-by: Dmitry Baryshkov

drm/msm/dsi: Switch the QCM2290-specific compatible to index autodetection

2023-04-06T17:29:45Z

Now that the logic can handle multiple sets of registers, move the QCM2290 to the common logic and mark it deprecated. This allows us to remove a couple of structs, saving some memory. Reviewed-by: Dmitry Baryshkov Reviewed-by: Marijn Suijten Signed-off-by: Konrad Dybcio Patchwork: https://patchwork.freedesktop.org/patch/527656/ Link: https://lore.kernel.org/r/20230307-topic-dsi_qcm-v6-6-70e13b1214fa@linaro.org Signed-off-by: Dmitry Baryshkov

drm/msm/dsi: dsi_cfg: Merge SC7180 config into SDM845

2023-04-06T17:29:44Z

The configs are identical, other than the number of *maximum* DSI hosts allowed. This isn't an issue, unless somebody deliberately tries to access the inexistent host by adding a dt node for it. Remove the SC7180 struct and point the hw revision match to the SDM845's one. On a note, this could have been done back when 7180 support was introduced. Reviewed-by: Dmitry Baryshkov Reviewed-by: Marijn Suijten Signed-off-by: Konrad Dybcio Patchwork: https://patchwork.freedesktop.org/patch/527654/ Link: https://lore.kernel.org/r/20230307-topic-dsi_qcm-v6-5-70e13b1214fa@linaro.org Signed-off-by: Dmitry Baryshkov

drm/msm/dsi: dsi_cfg: Deduplicate identical structs

2023-04-06T17:29:44Z

Some structs were defined multiple times for no apparent reason. Deduplicate them. Reviewed-by: Dmitry Baryshkov Reviewed-by: Marijn Suijten Signed-off-by: Konrad Dybcio Patchwork: https://patchwork.freedesktop.org/patch/527653/ Link: https://lore.kernel.org/r/20230307-topic-dsi_qcm-v6-4-70e13b1214fa@linaro.org Signed-off-by: Dmitry Baryshkov

drm/msm/dsi: Fix DSI index detection when version clash occurs

2023-04-06T17:29:44Z

Currently, we allow for MAX_DSI entries in io_start to facilitate for MAX_DSI number of DSI hosts at different addresses. The configuration is matched against the DSI CTRL hardware revision read back from the component. We need a way to resolve situations where multiple SoCs with different register maps may use the same version of DSI CTRL. In preparation to do so, make msm_dsi_config a 2d array where each entry represents a set of configurations adequate for a given SoC. This is totally fine to do, as the only differentiating factors between same-version-different-SoCs configurations are the number of DSI hosts (1 or 2, at least as of today) and the set of base registers. The regulator setup is the same, because the DSI hardware is the same, regardless of the SoC it was implemented in. In addition to that, update the matching logic such that it will loop over VARIANTS_MAX variants, making sure they are all taken into account. Reviewed-by: Dmitry Baryshkov Reviewed-by: Marijn Suijten Signed-off-by: Konrad Dybcio Patchwork: https://patchwork.freedesktop.org/patch/527652/ Link: https://lore.kernel.org/r/20230307-topic-dsi_qcm-v6-3-70e13b1214fa@linaro.org Signed-off-by: Dmitry Baryshkov

drm/msm/dsi: Get rid of msm_dsi_config::num_dsi

2023-04-06T17:29:44Z

In preparation for supporting multiple sets of possible base registers, remove the num_dsi variable. We're comparing the io_start array contents with the reg value from the DTS, so it will either match one of the expected values or don't match against a zero (which we get from partial array initialization). Reviewed-by: Dmitry Baryshkov Reviewed-by: Marijn Suijten Signed-off-by: Konrad Dybcio Patchwork: https://patchwork.freedesktop.org/patch/527658/ Link: https://lore.kernel.org/r/20230307-topic-dsi_qcm-v6-2-70e13b1214fa@linaro.org Signed-off-by: Dmitry Baryshkov

drm/msm: Update generated headers

2023-03-21T16:10:47Z

It's been a bit overdue. Regen headers to pull in a2xx perfcntr updates, etc. Signed-off-by: Rob Clark Patchwork: https://patchwork.freedesktop.org/patch/527926/ Link: https://lore.kernel.org/r/20230320185416.938842-2-robdclark@gmail.com