kernel.git/arch/sh/kernel/cpu/sh4a, branch linux-2.6.30.y

sh: sh7723: Don't default enable the RTC clock.

2009-04-16T05:16:33Z

rtc-sh takes care of this now, so no need to have this always enabled. Signed-off-by: Paul Mundt

sh: sh7722: Don't default enable the RTC clock.

2009-04-16T05:15:38Z

rtc-sh takes care of this now, so no need to have this always enabled. Signed-off-by: Paul Mundt

sh: sh7786: modify usb setup timeout judgment bug.

2009-04-13T22:25:35Z

This corrects a race with the PHY RST bit not being set properly if the PLL status changes right before timeout. This resulted in it potentially failing even if the device came up in time. Special thanks to Mr. Juha Leppanen and Iwamatsu-san for reporting this out and reviewing it. Reported-by: Juha Leppanen Reviewed-by: Nobuhiro Iwamatsu Tested-by: Paul Mundt Signed-off-by: Kuninori Morimoto Signed-off-by: Paul Mundt

sh: Tidy up sh7786 pinmux table.

2009-03-30T22:39:51Z

Formatting and typo fix. Signed-off-by: Kuninori Morimoto Signed-off-by: Paul Mundt

sh: Remove buggy definition from SH7786 pinmux_data[]

2009-03-30T22:36:24Z

Signed-off-by: Kuninori Morimoto Signed-off-by: Paul Mundt

sh: Consolidate SH-Mobile CPU code in arch/sh/kernel/cpu/shmobile/.

2009-03-16T11:00:17Z

Signed-off-by: Paul Mundt

sh: SuperH Mobile suspend support

2009-03-16T10:52:53Z

This patch contains CONFIG_SUSPEND support to the SuperH architecture. If enabled, SuperH Mobile processors will register their suspend callbacks during boot. To suspend, use "echo mem > /sys/power/state". To allow wakeup, make sure "/sys/device/platform/../power/wakeup" contains "enabled". Additional per-device driver patches are most likely needed. Signed-off-by: Magnus Damm Signed-off-by: Paul Mundt

sh: Add OHCI USB support for SH7786

2009-03-16T10:40:34Z

Signed-off-by: Kuninori Morimoto Signed-off-by: Paul Mundt

sh: Restore RTC IRQ setting for SH7763 setup.

2009-03-06T05:37:34Z

This was accidentally dropped in the multiple vectors per irq conversion. Signed-off-by: Nobuhiro Iwamatsu Signed-off-by: Paul Mundt

sh: multiple vectors per irq - sh7763

2009-03-06T05:18:43Z

Update intc tables and platform data to use one linux irq per maskable interrupt source instead of keeping the one-to-one mapping between vectors and linux irqs. This fixes potential irq masking issues for sh7763 hardware blocks such as RTC/SCIF/DMAC/GETHER/PCIC5/MMCIF/SIM/GPIO/USBF. Signed-off-by: Nobuhiro Iwamatsu Signed-off-by: Paul Mundt