kernel.git/Documentation/devicetree/bindings/mtd, branch linux-3.10.y

Merge tag 'omap-for-v3.10/fixes-for-merge-window-part2' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into fixes

2013-05-09T20:13:57Z

From Tony Lindgren: Omap fixes for things that were discovered during the merge window: - Few GPMC fixes and binding doc updates noted after sending pull requests for the GPMC branch. - Board fixes for beagle usb host and rx51 spi probe order - SoC fixes dt earlyprintk, omap1 dma and omap2+ id.c error handling fixes Then few minor things that are not strictly fixes but are good to get out of the way: - Add missing legacy mux registers for am/dm73x gpio - Add detection for am33xx pg2.1 silicon - Enable twl4030 audio modules in defconfig * tag 'omap-for-v3.10/fixes-for-merge-window-part2' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap: ARM: OMAP2+: Remove bogus IS_ERR_OR_NULL checking from id.c ARM: OMAP4+: omap2plus_defconfig: Enable audio via TWL6040 as module ARM: OMAP2: AM33XX: id: Add support for new AM335x PG2.1 Si omap: mux: add AM/DM37x gpios ARM: OMAP1: DMA: fix error handling in omap1_system_dma_init() ARM: OMAP2+: omap_device: use late_initcall_sync ARM: OMAP: RX-51: change probe order of touchscreen and panel SPI devices ARM: OMAP3: Beagle: Fix USB Host on beagle xM Ax/Bx ARM: OMAP2+: only WARN if a GPMC child probe function fail ARM: OMAP2+: only search for GPMC DT child nodes on probe Documentation: dt: update properties in TI GPMC NAND example Documentation: dt: update TI GPMC ethernet binding properties Signed-off-by: Olof Johansson

Merge tag 'for-linus-20130509' of git://git.infradead.org/linux-mtd

2013-05-09T17:15:46Z

Pull MTD update from David Woodhouse: - Lots of cleanups from Artem, including deletion of some obsolete drivers - Support partitions larger than 4GiB in device tree - Support for new SPI chips * tag 'for-linus-20130509' of git://git.infradead.org/linux-mtd: (83 commits) mtd: omap2: Use module_platform_driver() mtd: bf5xx_nand: Use module_platform_driver() mtd: denali_dt: Remove redundant use of of_match_ptr mtd: denali_dt: Change return value to fix smatch warning mtd: denali_dt: Use module_platform_driver() mtd: denali_dt: Fix incorrect error check mtd: nand: subpage write support for hardware based ECC schemes mtd: omap2: use msecs_to_jiffies() mtd: nand_ids: use size macros mtd: nand_ids: improve LEGACY_ID_NAND macro a bit mtd: add 4 Toshiba nand chips for the full-id case mtd: add the support to parse out the full-id nand type mtd: add new fields to nand_flash_dev{} mtd: sh_flctl: Use of_match_ptr() macro mtd: gpio: Use of_match_ptr() macro mtd: gpio: Use devm_kzalloc() mtd: davinci_nand: Use of_match_ptr() mtd: dataflash: Use of_match_ptr() macro mtd: remove h720x flash support mtd: onenand: remove OneNAND simulator ...

Merge branch 'omap-gpmc-fixes-for-v3.10' of git://github.com/jonhunter/linux into fixes

2013-05-09T00:06:39Z

Merge tag 'dt-for-linus-2' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2013-05-07T18:06:17Z

Pull ARM SoC device tree updates (part 2) from Arnd Bergmann: "These are mostly new device tree bindings for existing drivers, as well as changes to the device tree source files to add support for those devices, and a couple of new boards, most notably Samsung's Exynos5 based Chromebook. The changes depend on earlier platform specific updates and touch the usual platforms: omap, exynos, tegra, mxs, mvebu and davinci." * tag 'dt-for-linus-2' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (169 commits) ARM: exynos: dts: cros5250: add EC device ARM: dts: Add sbs-battery for exynos5250-snow ARM: dts: Add i2c-arbitrator bus for exynos5250-snow ARM: dts: add mshc controller node for Exynos4x12 SoCs ARM: dts: Add chip-id controller node on Exynos4/5 SoC ARM: EXYNOS: Create virtual I/O mapping for Chip-ID controller using device tree ARM: davinci: da850-evm: add SPI flash support ARM: davinci: da850: override SPI DT node device name ARM: davinci: da850: add SPI1 DT node spi/davinci: add DT binding documentation spi/davinci: no wildcards in DT compatible property ARM: dts: mvebu: Convert mvebu device tree files to 64 bits ARM: dts: mvebu: introduce internal-regs node ARM: dts: mvebu: Convert all the mvebu files to use the range property ARM: dts: mvebu: move all peripherals inside soc ARM: dts: mvebu: fix cpus section indentation ARM: davinci: da850: add EHRPWM & ECAP DT node ARM/dts: OMAP3: fix pinctrl-single configuration ARM: dts: Add OMAP3430 SDP NOR flash memory binding ARM: dts: Add NOR flash bindings for OMAP2420 H4 ...

Documentation: dt: update properties in TI GPMC NAND example

2013-04-30T13:42:54Z

The GPMC timing properties for device-tree have been updated by adding a "-ns" or "-ps" suffix to indicate the units of time the property represents. Therefore, update the timing property names for TI GPMC NAND example. Signed-off-by: Jon Hunter Acked-by: Grant Likely

mtd: ofpart: support partitions of 4 GiB and larger

2013-04-05T11:05:53Z

Previously, partitions were limited to less than 4 GiB in size because the address and size were read as 32-bit values. Add support for 64-bit values to support devices of 4 GiB and larger. Signed-off-by: Joe Schaack Signed-off-by: Nate Case Signed-off-by: Aaron Sierra Signed-off-by: Artem Bityutskiy Signed-off-by: David Woodhouse

mtd: gpmi: move to use generic DMA helper

2013-04-04T13:22:45Z

With the generic DMA device tree helper supported by mxs-dma driver, client devices only need to call dma_request_slave_channel() for requesting a DMA channel from dmaengine. Signed-off-by: Shawn Guo Acked-by: Artem Bityutskiy Reviewed-by: Arnd Bergmann

ARM: OMAP2+: Convert ONENAND to retrieve GPMC settings from DT

2013-04-04T01:13:39Z

When booting with device-tree, retrieve GPMC settings for ONENAND from the device-tree blob. This will allow us to remove all static settings stored in the gpmc-nand.c in the future once the migration to device-tree is complete. The user must now specify the ONENAND device width in the device-tree binding so that the GPMC can be programmed correctly. Therefore, update the device-tree binding documentation for ONENAND devices connected to the GPMC to reflect this. Please note that this does not include GPMC timings for ONENAND. The timings are being calculated at runtime. There is some legacy code that only enables read wait monitoring for non-OMAP3 devices. There are no known OMAP3 device issues that prevent this feature being enabled and so when booting with device-tree use the wait-monitoring settings described in the device-tree blob. Signed-off-by: Jon Hunter Tested-by: Ezequiel Garcia

ARM: OMAP2+: Add device-tree support for NOR flash

2013-04-04T01:13:38Z

NOR flash is not currently supported when booting with device-tree on OMAP2+ devices. Add support to detect and configure NOR devices when booting with device-tree. Add documentation for the TI GPMC NOR binding. Signed-off-by: Jon Hunter Tested-by: Ezequiel Garcia

Merge tag 'for-linus-20130301' of git://git.infradead.org/linux-mtd

2013-03-03T00:33:54Z

Pull MTD update from David Woodhouse: "Fairly unexciting MTD merge for 3.9: - misc clean-ups in the MTD command-line partitioning parser (cmdlinepart) - add flash locking support for STmicro chips serial flash chips, as well as for CFI command set 2 chips. - new driver for the ELM error correction HW module found in various TI chips, enable the OMAP NAND driver to use the ELM HW error correction - added number of new serial flash IDs - various fixes and improvements in the gpmi NAND driver - bcm47xx NAND driver improvements - make the mtdpart module actually removable" * tag 'for-linus-20130301' of git://git.infradead.org/linux-mtd: (45 commits) mtd: map: BUG() in non handled cases mtd: bcm47xxnflash: use pr_fmt for module prefix in messages mtd: davinci_nand: Use managed resources mtd: mtd_torturetest can cause stack overflows mtd: physmap_of: Convert device allocation to managed devm_kzalloc() mtd: at91: atmel_nand: for PMECC, add code to check the ONFI parameter ECC requirement. mtd: atmel_nand: make pmecc-cap, pmecc-sector-size in dts is optional. mtd: atmel_nand: avoid to report an error when lookup table offset is 0. mtd: bcm47xxsflash: adjust names of bus-specific functions mtd: bcm47xxpart: improve probing of nvram partition mtd: bcm47xxpart: add support for other erase sizes mtd: bcm47xxnflash: register this as normal driver mtd: bcm47xxnflash: fix message mtd: bcm47xxsflash: register this as normal driver mtd: bcm47xxsflash: write number of written bytes mtd: gpmi: add sanity check for the ECC mtd: gpmi: set the Golois Field bit for mx6q's BCH mtd: devices: elm: Removes literals in elm DT node mtd: gpmi: fix a dereferencing freed memory error mtd: fix the wrong timeo for panic_nand_wait() ...